{"id":4871,"date":"2016-01-28T17:32:19","date_gmt":"2016-01-28T12:32:19","guid":{"rendered":"http:\/\/www.cawater-info.net\/all_about_water\/en\/?p=4871"},"modified":"2016-01-28T17:32:19","modified_gmt":"2016-01-28T12:32:19","slug":"how-to-boil-water-without-bubbles","status":"publish","type":"post","link":"http:\/\/www.cawater-info.net\/all_about_water\/en\/?p=4871","title":{"rendered":"How to boil water without bubbles"},"content":{"rendered":"

One trick to test whether a frying pan is hot enough is to sprinkle water on it. If the surface is sufficiently above the boiling point of water, droplets will skip across the pan. Those jittery beads of water are held up from the hot pan by a cushion of steam. The vapour cushion collapses as the surface falls below the ‘Leidenfrost temperature’, causing furious bubbling and spitting when the water droplet hits the surface and boils explosively.<\/em><\/p>\n

\"001\"<\/a>The Leidenfrost effect lies behind the discovery, published today in Nature1, that water can be made to boil without any bubbling if a surface is specially treated so that the vapour cushion does not break down. The key is to make the surface very water-repellent, according to Ivan Vakarelski, an engineer at the Clean Combustion Research Center at the King Abdullah University of Science and Technology in Thuwal, Saudi Arabia, and his colleagues. The effect might be used to carefully control how metals are cooled and heated, or to reduce drag on ships.<\/p>\n

The rough with the smooth<\/strong>
\nVakarelski\u2019s team covered metal spheres with a commercially available coating that made the surface rough and strongly water-repellent, and heated these superhydrophobic spheres to 400 \u00b0C (any higher and the coating would deteriorate). For comparison, they heated a set of smooth, water-attracting spheres to 700 \u00b0C.<\/p>\n

Each hot sphere was dropped into room-temperature water, where a layer of water vapour formed around it. The vapour layers around the water-loving spheres quickly collapsed, leading to explosive bubbling. The coated spheres, by contrast, kept their vapour layers as they cooled down, with no bubbling or explosive boiling.<\/p>\n

\u201cWe thought we could improve the transition\u201d from the Leidenfrost regime to bubbling, says Vakarelski, \u201cbut we are not only lowering the transition, we are completely avoiding it\u201d.<\/p>\n

\u201cIt was really dramatic,\u201d says Neelesh Patankar, a theoretical mechanical engineer at Northwestern University in Evanston, Illinois, and a co-author of the paper. \u201cAs the temperature goes down, this vapour phase nicely settles down.\u201d<\/p>\n

The implications of the work could be far-reaching, says Vincent Craig, an applied mathematician at the Australian National University in Canberra, who studies the physics of surface forces and bubbles. \u201cThey\u2019ve shown that by keeping the surface rough you can keep that vapour layer at low temperature.\u201d The effect could be used to reduce drag on surfaces such as the tiny channels in microfluidic devices, he suggests.<\/p>\n

Hot stuff<\/strong>
\nIn a related experiment, the team dipped metal rods with the same water-loving and water-hating surfaces into water. Heaters inside the rods warmed them, while probes monitored their temperature. The water-loving rods could only ever reach 106 \u00b0C, because the water was always coming into contact with the metal and cooling it. But the coated spheres got up to 250 \u00b0C, because they were constantly protected from the cool water by the vapour layer.<\/p>\n

The next step, says Patankar, is to try to get the vapour layer to form at temperatures much lower than the boiling point of water. Water can exist as either liquid or vapour at room temperature, but it requires energy to stay in the vapour state. Patankar thinks that a surface could be designed that would make the vapour state more stable. A coating could then be used to form a vapour layer round a ship\u2019s hull to reduce drag or discourage organisms such as algae or barnacles from attaching themselves to the ship, he suggests. \u201cIt will be mind-blowing,\u201d says Patankar. \u201cWho thinks of getting a vapour without heating?\u201d<\/p>\n

Source: http:\/\/www.nature.com\/<\/a><\/p>\n

Dear User\/Visitor! Please, answer on our questions: tick off one of the positions – your answer will make us able to improve our site and make it more interesting and useful!<\/strong><\/em><\/p>\n

\n\t
\n\t\t

<\/p>\n\t\t

<\/p>\n\t\t

What materials need to be added on the site?<\/strong><\/p>